[MR-PDC2]隔離電源分配器 Isolation power distributor (2ch)

This converter is used to supply power all types of
transmitter used at the site and to output insulated
signal by receiving the signal.
With built-in noise removal filter, transfers correct
signal, and precision isolation circuits enable
perfect signal transfer not affected by withstand
insulation voltage, transfer speed, noise, etc.

FEATURES
Small size(mm) : 83(H), 51(W), 102(D).
Isolation : input to output to power supply.
Power supply : AC or DC supply.
Wiring : terminal socket wiring.
Case & color : black ABS plastic case.
Weight : about 400g
MR - PDC2
INPUT SIGNAL SPECIFICATION
OUTPUT SIGNAL SPECIFICATION
Output voltage signal : 12VDC max.
Output voltage impedance : 2Kohm min.
Output voltage noise : 10mV p-p max.
Output current signal : 30mADC max.
Output load resistance : 750ohm max.
Output current noise(250ohm load) : 10mV p-p.
GENERAL SPECIFICATION'S
Operating ambient temperature : 0 - 50'C.
Non operating ambient temperature : -20 ~ 80'C.
Temperature coefficient : 0.015%/'C.
Operating ambient humidity : 90% RH max.(non condensing)
Insulation resistance : greater than 100Mohm with 500VDC.
Dielectric strength : 1500VAC @ 1minute (input/out1/out2/power).
Adjustment range : 20% (zero & span) min.
Conversion accuracy : 0.2% max.
Response time : 0 - 90%(0.5sec).
OUTPUT IMPEDANCE OUTPUT LOAD - R
0 - 1VDC
0 - 5VDC
1 - 5VDC
0 - 10VDC
0 - 1mA
0 - 20mA
1 - 5mA
4 - 20mA
> 1Kohm
> 2Kohm
> 2Kohm
> 4Kohm
< 15Kohm
< 750ohm
< 3Kohm
< 750ohm
Input current signal : 30mADC max.
Input current load resistance : 100ohm max.(at 20mA)
External power source : DC22~26V / 30mA Max.
DISPLAY (OPTION)
Type : 3 digit FND
Display font : red super bright
Display function's : input or output or percent(%).
Display error : 1digit(LSB).
DISPLAY SIGNAL
1 : Input signal
2 : Output signal
3 : Percent(%)
OUTPUT SIGNAL1
1 : 0 - 1mADC
2 : 0 - 20mADC
3 : 1 - 5mADC
4 : 4 - 20mADC
5 : 0 - 1VDC
6 : 0 - 5VDC
7 : 1 - 5VDC
8 : 0 - 10VDC
9 : Specify signal
DISPLAY & POWER DISTRIBUTOR 2OUT CONVERTER
This converter is used to supply power all types of
transmitter used at the site and to output insulated
signal by receiving the signal.
With built-in noise removal filter, transfers correct
signal, and precision isolation circuits enable
perfect signal transfer not affected by withstand
insulation voltage, transfer speed, noise, etc.