1.優化的內置式直驅伺服馬達；圓刀剪線設計；低振動、低噪音、安裝方便、清潔環保；結合了航空航天技術，起縫、停車迅速、停針定位精準，0至4000針的轉換只需0.12秒；無“V”字型皮帶傳動，*解決了因皮帶摩擦而產生的料屑污染、皮帶纏線的問題，并且大大減少停車、提速時的故障率，提高縫制效率。

The patented optimal inserted direct-drive servomotor. Rotary cutter. Convenient installation, cleannon-polluted, low noisevibration. Combined with aerospace technology, high speed startup/brake, precise needle stop locating. It only takes 0.12s from 0 to 4000 stitches. The absence of V-belt avoids belt abrasionspooling thoroughly. Reduce greatly the failure rateimprove highly sewing efficiency.

2.與普通電機相比，直驅三自動（圓刀）電腦高速平縫機操作系統省電60%左右，同比變頻伺服馬達省電30%以上。

High power saving: save about 60% of energy compared with the common motors, 30% up with frequency servo motor.

3.直驅三自動（圓刀）電腦高速平縫機采用了參數設定改變踏板起縫，操作簡便；顯示故障代碼便于故障的確認與排除。

Parameter setting the startup makes the operation easy; the error codes will show on the

panel for faults confirmationelimination.

4.縫制結束以后，剪完線頭只剩下4-5mm，無需進行線屑清除的作業。

Thread end lefts only 4-5mm after stopping, so it isn''t necessary to remove the litters.

5.如果按下手動倒縫開關（設置在機針附近的開關），即可進行倒縫工作，操作十分方便。

Press manual reverse stitching switch （near to needle）, perform the operation very easily.