西門子6EP1332-4BA00型號及參數 西門子6EP1332-4BA00型號及參數 

6EP1332-4BA00 SIMATIC PM 1507 24 V/3 A 調節電源 用于 SIMATIC S7-1500 輸入：AC 120/230 V 輸出：DC 24 V/3 A

公司名稱：上海朔川電氣設備有限公司

• 聯 系 人：吉夢琪
• ：
• 地址：上海市金山區涇波路129號
• ：2840735331

• 負載電源 訂貨數據   附件   產品信息   組態工具 跳轉到 概述 設計 功能 技術規范 附件 概述 SIMATIC PM 1507 單相負載電源（PM = 電源模塊）具有輸入電壓范圍自動選擇功能。其設計和功能非常適用于 SIMATIC S7-1500 PLC。它為 S7-1500 系統組件（例如，CPU、系統電源（PS）、輸入和輸出模塊的 I/O 電路等）供電；必須時，也可以向傳感器和執行器提供 24 VDC 電源。 設計 這些負載電源可直接固定到 S7-1500 安裝導軌上（不連接到背板總線），并可直接安裝到 CPU 的左側（無需留出安裝間隙） 狀態和故障診斷顯示 LED：運行、故障、待機 更換模塊時使用的 ON/OFF 開關（運行/待機） 電源連接插頭帶防觸摸保護，通過電纜松緊件來連接輸入電纜（可進行固定接線） 插入式 24 V DC 輸出端子帶極性反接保護，用于連接 24 V 負載（可進行固定接線） 功能 通過自動范圍切換，連接至所有 50/60 Hz (120 / 230 V AC) 單相電網 短時間電源緩沖 輸出 24 V DC 電壓，zui高限制在 28 V DC（防止過高的電壓對 24 V 負載造成損壞） 針對短時間過載，每分鐘有 5 秒可有 50% 的“額外功率”，例如在切換 24V 用電設備時 可并聯兩個負載電源以提高性能 技術規范 Article number 6EP1332-4BA00 6EP1333-4BA00 Product S7-1500 PM1507 S7-1500 PM1507 Power supply, type 24 V/3 A 24 V/8 A Input     Input 1-phase AC 1-phase AC Supply voltage     ● 1 at AC Rated value 120 V 120 V ● 2 at AC Rated value 230 V 230 V ● Note Automatic range selection Automatic range selection Input voltage     ● 1 at AC 85 ... 132 V 85 ... 132 V ● 2 at AC 170 ... 264 V 170 ... 264 V Wide-range input No No Overvoltage resistance 2.3 × Vin rated, 1.3 ms 2.3 × Vin rated, 1.3 ms Mains buffering at Iout rated, min. 20 ms; at Vin = 93/187 V 20 ms; at Vin = 93/187 V Rated line frequency 1 50 Hz 50 Hz Rated line frequency 2 60 Hz 60 Hz Rated line range 45 ... 65 Hz 45 ... 65 Hz Input current     ● at rated input voltage 120 V 1.4 A 3.7 A ● at rated input voltage 230 V 0.8 A 1.7 A Switch-on current limiting (+25 °C), max. 23 A 62 A Duration of inrush current limiting at 25 °C     ● maximum 3 ms 3 ms I²t, max. 1.3 A²·s 12 A²·s Built-in incoming fuse T 3,15 A/250 V (not accessible) T 6.3 A/250 V (not accessible) Protection in the mains power input (IEC 898) Recommended miniature circuit breaker: 10 A characteristic B or 6 A characteristic C Recommended miniature circuit breaker: 16 A characteristic B or 10 A characteristic C Output     Output Controlled, isolated DC voltage Controlled, isolated DC voltage Rated voltage Vout DC 24 V 24 V Total tolerance, static ± 1 % 1 % Static mains compensation, approx. 0.1 % 0.1 % Static load balancing, approx. 0.1 % 0.1 % Residual ripple peak-peak, max. 50 mV 50 mV Spikes peak-peak, max. (bandwidth: 20 MHz) 150 mV 150 mV Product function Output voltage adjustable No No Status display LED green for 24 V OK; LED red for error; LED yellow for stand-by LED green for 24 V OK; LED red for error; LED yellow for stand-by On/off behavior No overshoot of Vout (soft start) No overshoot of Vout (soft start) Startup delay, max. 1.5 s 1.5 s Voltage rise, typ. 10 ms 10 ms Rated current value Iout rated 3 A 8 A Current range 0 ... 3 A 0 ... 8 A Supplied active power typical 72 W 192 W Short-term overload current     ● on short-circuiting during the start-up typical 12 A 35 A ● at short-circuit during operation typical 12 A 35 A Duration of overloading capability for excess current     ● on short-circuiting during the start-up 70 ms 70 ms ● at short-circuit during operation 70 ms 70 ms Parallel switching for enhanced performance No No Efficiency     Efficiency at Vout rated, Iout rated, approx. 87 % 90 % Power loss at Vout rated, Iout rated, approx. 11 W 21 W Closed-loop control     Dynamic mains compensation (Vin rated ±15 %), max. 0.1 % 0.1 % Dynamic load smoothing (Iout: 50/100/50 %), Uout ± typ. 1 % 2 % Dynamic load smoothing (Iout: 10/90/10 %), Uout ± typ. 3 % 3 % Load step setting time 10 to 90%, typ. 5 ms 5 ms Load step setting time 90 to 10%, typ. 5 ms 5 ms Setting time maximum 5 ms 5 ms Protection and monitoring     Output overvoltage protection Additional control loop, limitation (closed loop control) at < 28.8 V Additional control loop, limitation (closed loop control) at < 28.8 V Current limitation 3.15 ... 3.6 A 8.4 ... 9.6 A Current limitation, typ. 3.4 A 9 A Property of the output Short-circuit proof Yes Yes Short-circuit protection Electronic shutdown, automatic restart Electronic shutdown, automatic restart Overload/short-circuit indicator - - Safety     Primary/secondary isolation Yes Yes Galvanic isolation Safety extra-low output voltage Uout acc. to EN 60950-1 and EN 50178 and EN 61131-2 Safety extra-low output voltage Uout acc. to EN 60950-1 and EN 50178 and EN 61131-2 Protection class Class I Class I Leakage current     ● maximum 3.5 mA 3.5 mA ● typical 0.4 mA 1.3 mA CE mark Yes Yes UL/cUL (CSA) approval cULus-Listed (UL 508, CSA C22.2 No. 142), File E143289 cULus-Listed (UL 508, CSA C22.2 No. 142), File E143289 Explosion protection IECEx Ex nA nC IIC T4 Gc; ATEX (EX) II 3G Ex nA nC IIC T4 Gc; cULus (ISA 12.12.01, CSA C22.2 No.213) Class I, Div. 2, Group ABCD, T4, File E330455 IECEx Ex nA nC IIC T3 Gc; ATEX (EX) II 3G Ex nA nC IIC T3 Gc; cULus (ISA 12.12.01, CSA C22.2 No.213) Class I, Div. 2, Group ABCD, T3, File E330455 FM approval Class I, Div. 2, Group ABCD, T4 Class I, Div. 2, Group ABCD, T4 CB approval Yes Yes Marine approval GL, ABS, BV, DNV GL, ABS, BV, DNV Degree of protection (EN 60529) IP20 IP20 EMC     Emitted interference EN 55022 Class B EN 55022 Class B Supply harmonics limitation EN 61000-3-2 EN 61000-3-2 Noise immunity EN 61000-6-2 EN 61000-6-2 Operating data     Ambient temperature     ● during operation 0 ... 60 °C 0 ... 60 °C — Note with natural convection with natural convection ● during transport -40 ... +85 °C -40 ... +85 °C ● during storage -40 ... +85 °C -40 ... +85 °C Humidity class according to EN 60721 Climate class 3K3, no condensation Climate class 3K3, no condensation Mechanics     Connection technology Screw-/spring clamp connection Screw-/spring clamp connection Connections     ● Supply input L, N, PE: 1 screw terminal each for 0.5 ... 2.5 mm² L, N, PE: 1 screw terminal each for 0.5 ... 2.5 mm² ● Output L+, M: 2 spring-loaded terminals each for 0.5 to 2.5 mm² L+, M: 2 spring-loaded terminals each for 0.5 to 2.5 mm² Product function     ● removable terminal at input Yes Yes ● removable terminal at output Yes Yes Width of the enclosure 50 mm 75 mm Height of the enclosure 147 mm 147 mm Depth of the enclosure 129 mm 129 mm Required spacing     ● top 50 mm   ● bottom 50 mm   ● left 0 mm   ● right 0 mm   Weight, approx. 0.45 kg 0.74 kg Product feature of the enclosure housing for side-by-side mounting Yes Yes Installation Can be mounted onto S7-1500 rail Can be mounted onto S7-1500 rail MTBF at 40 °C 1 611 993 h 1 362 918 h Other information Specifications at rated input voltage and ambient temperature +25 °C (unless otherwise specified) Specifications at rated input voltage and ambient temperature +25 °C (unless otherwise specified)   附件 電源連接器 6ES7590-8AA00-0AA0 帶編碼單元，用于電源模塊；備件， 每包 10 個     全部關于 負載電源 產品與解決方案在線目錄與訂購系統技術信息服務與支持與合作伙伴服務項目