詳細介紹
騰達試驗儀器廠:
巖石膨脹壓力試驗儀概述:
該儀器為數字顯示,手動轉動絲杠施加壓力,適用于各類巖石膨脹性試驗中的體積不變條件下的膨脹壓力試驗,配有透水板,千分表等試驗裝置。
Rock Expansion Pressure Tester Overview:
The instrument is a digital display,and the pressure is manually applied to the screw.It is suitable for the expansion pressure test under the constant volume condition in various rock expansion tests.It is equipped with a test device such as a water permeable plate and a dial gauge.
巖石膨脹壓力試驗儀技術參數:
■大試驗力:40KN
■精度:優于1級
■壓縮空間:170mm
■立柱間距:165mm
■玻璃鋼環直徑:141mm
■玻璃剛環高度:66mm
■金屬環直徑:50mm
■金屬環高度:55mm
■主機外形尺寸:320*320*500mm
Rock expansion pressure tester technical parameters:
■Large test force:40KN
■Accuracy:better than level 1
■Compression space:170mm
■Pitch spacing:165mm
■Glass steel ring diameter:141mm
■Glass ring height:66mm
■Metal ring diameter:50mm
■Metal ring height:55mm
■Mainframe dimensions:320*320*500mm
巖石膨脹壓力試驗儀試驗步驟:
■將試件放人內壁涂有凡士林的金屬套環內,在試件上下分別放置薄型濾紙和金屬透水板。
■安裝加壓系統及量測試件變形的測表。
■應使儀器各部位和試件在同一軸線上,不得出現偏心荷載。
■對試件施加產生O.O1MPa壓力的荷載,測讀試件變形測表讀數,每隔l0min讀數1次,直至3次讀數不變。
■加的荷載,應保持試件高度在整個試驗過程始終不變。
■開始時每隔10min讀數1次,連續3次讀數差小于0.001mm時,改為每1h讀數1次
■浸水后總試驗時間不得少于48h.
■試驗過程中,應保持水位不變。水溫變化不得大于2℃
■試驗結束后,應描述試件表面的泥化和軟化現象。
Rock expansion pressure tester test steps:
■Place the test piece on the inner wall of the metal collar of Vaseline,and place thin filter paper and metal permeable plate on top of the test piece.
■Installation of the pressure system and the measurement of the deformation of the test piece.
■The parts of the instrument and the test piece should be on the same axis,and no eccentric load should occur.
■Apply a load of O.O1MPa pressure to the test piece,read the deformation table reading of the test piece,and read it every l0min until the reading is unchanged.
■For the applied load,the height of the test piece should be kept constant throughout the test.
■Read every 10 minutes at the beginning,and change the readings every 1h to 1 time for 3 consecutive readings.
■The total test time after water immersion shall not be less than 48h.
■The water level should be kept constant during the test.Water temperature change must not exceed 2°C
■After the test,the muddy and softened surface of the test piece should be described.
巖石膨脹壓力試驗儀試驗記錄:
膨脹性試驗記錄應包括巖石名稱、試驗編號、試件編號、試件描述、試件尺寸、溫度、試驗時間、軸向變形、徑向變形和軸向荷載。
Rock expansion pressure tester test record:
The expansive test record shall include the rock name,test number,test piece number,test piece description,test piece size,temperature,test time,axial deformation,radial deformation and axial load.